Daily Papers

Fiber Fabry--Perot (FFP) resonators of a few centimeters are optimized as a function of the reflectivity of the mirrors and the dimensions of the intra-cavity waveguide. Loaded quality factor in excess of 10^9, with an optimum of 4___x___10^9, together with an intrinsic quality factor larger than 10^10 and intrinsic finesse in the range of 10^5 have been measured. An application to the stabilization of laser frequency fluctuations is presented.

This work culminates in a demonstration of an alternative Frequency Domain Multiplexing (FDM) scheme for Superconducting Nanowire Single-Photon Detectors (SNSPDs) using the Kinetic inductance Parametric UP-converter (KPUP) made out of NbTiN. There are multiple multiplexing architectures for SNSPDs that are already in use, but FDM could prove superior in applications where the operational bias currents are very low, especially for mid- and far-infrared SNSPDs. Previous FDM schemes integrated the SNSPD within the resonator, while in this work we use an external resonator, which gives more flexibility to optimize the SNSPD architecture. The KPUP is a DC-biased superconducting resonator in which a nanowire is used as its inductive element to enable sensitivity to current perturbations. When coupled to an SNSPD, the KPUP can be used to read out current pulses on the few μA scale. The KPUP is made out of NbTiN, which has high non-linear kinetic inductance for increased sensitivity at higher current bias and high operating temperature. Meanwhile, the SNSPD is made from WSi, which is a popular material for broadband SNSPDs. To read out the KPUP and SNSPD array, a software-defined radio platform and a graphics processing unit are used. Frequency Domain Multiplexed SNSPDs have applications in astronomy, remote sensing, exoplanet science, dark matter detection, and quantum sensing.

Developing the field of neuromorphic quantum computing necessitates designing scalable quantum memory devices. Here, we propose a superconducting quantum memory device in the microwave regime, termed as a microwave quantum memcapacitor. It comprises two linked resonators, the primary one is coupled to a Superconducting Quantum Interference Device, which allows for the modulation of the resonator properties through external magnetic flux. The auxiliary resonator, operated through weak measurements, provides feedback to the primary resonator, ensuring stable memory behaviour. This device operates with a classical input in one cavity while reading the response in the other, serving as a fundamental building block toward arrays of microwave quantum memcapacitors. We observe that a bipartite setup can retain its memory behaviour and gains entanglement and quantum correlations. Our findings pave the way for the experimental implementation of memcapacitive superconducting quantum devices and memory device arrays for neuromorphic quantum computing.

Sagnac Speed Meter and ring resonators can be used as high precision instruments, but they are limited in their sensitivity through scattered light causing non-linear noise. Here, we experimentally demonstrate a technique called Tunable Coherence, where the long coherence length of the laser is broken in a controlled way, to suppress the coupling of scattered light in a Sagnac interferometer. We demonstrate a scattered light suppression of 24.2 dB in a Sagnac interferometer and discuss the experimental limitations. Further, we show an analytical discussion on how Tunable Coherence could be a fundamental solution to light scattering back from optical surfaces into the counter propagating beam, which is an issue particularly in ring resonators.

The superconducting materials that make up an MKID have a significant effect on its performance. The T_c and normal state resistivity ρ_N of the film determine the penetration depth λ and therefore how much kinetic inductance it has. The ratio of kinetic inductance to total inductance (α), the volume of the inductor, and Q_m determines the magnitude of the response to incoming energy. The quasiparticle lifetime τ_qp is the characteristic time during which the MKID's surface impedance is modified by the incoming energy. Many materials have been explored for use in superconducting resonators and MKIDs, but that information is often not published or scattered around the literature. This chapter contains information and references on the work that has been done with thin film lithographed circuits for MKIDs over the last two decades. Note that measured material properties such as the internal loss quality factor Q_i and quasiparticle lifetime τ_qp vary significantly depending on how the MKID superconducting thin film is made and the system they are measured in, so it is best to interpret all stated values as typical but not definitive. Values are omitted in cases when there aren't enough measurements or there is too much disagreement in the literature to estimate a typical value. In order to be as complete as possible some unpublished results from the author's lab are included and can be identified by the lack of a reference. Unless noted all films are polycrystalline or amorphous.

Through rational chemical design, and thanks to the hybrid nature of metal-organic frameworks (MOFs), it is possible to prepare molecule-based 2D magnetic materials stable at ambient conditions. Here, we illustrate the versatility of this approach by changing both the metallic nodes and the ligands in a family of layered MOFs that allows the tuning of their magnetic properties. Specifically, the reaction of benzimidazole-type ligands with different metal centres (MII = Fe, Co, Mn, Zn) in a solvent-free synthesis produces a family of crystalline materials, denoted as MUV-1(M), which order antiferromagnetically with critical temperatures that depend on M. Furthermore, the incorporation of additional substituents in the ligand results in a novel system, denoted as MUV-8, formed by covalently bound magnetic double-layers interconnected by van der Waals interactions, a topology that is very rare in the field of 2D materials and unprecedented for 2D magnets. These layered materials are robust enough to be mechanically exfoliated down to a few layers with large lateral dimensions. Finally, the robustness and crystallinity of these layered MOFs allow the fabrication of nanomechanical resonators that can be used to detect -- through laser interferometry -- the magnetic order in thin layers of these 2D molecule-based antiferromagnets.