new

Get trending papers in your email inbox!

Subscribe

Daily Papers

byAK and the research community

Apr 14

Superconducting Materials for Microwave Kinetic Inductance Detectors

The superconducting materials that make up an MKID have a significant effect on its performance. The T_c and normal state resistivity ρ_N of the film determine the penetration depth λ and therefore how much kinetic inductance it has. The ratio of kinetic inductance to total inductance (α), the volume of the inductor, and Q_m determines the magnitude of the response to incoming energy. The quasiparticle lifetime τ_qp is the characteristic time during which the MKID's surface impedance is modified by the incoming energy. Many materials have been explored for use in superconducting resonators and MKIDs, but that information is often not published or scattered around the literature. This chapter contains information and references on the work that has been done with thin film lithographed circuits for MKIDs over the last two decades. Note that measured material properties such as the internal loss quality factor Q_i and quasiparticle lifetime τ_qp vary significantly depending on how the MKID superconducting thin film is made and the system they are measured in, so it is best to interpret all stated values as typical but not definitive. Values are omitted in cases when there aren't enough measurements or there is too much disagreement in the literature to estimate a typical value. In order to be as complete as possible some unpublished results from the author's lab are included and can be identified by the lack of a reference. Unless noted all films are polycrystalline or amorphous.

  • 1 authors
·
Apr 28, 2020

Imaging and controlling electron motion and chemical structural dynamics of biological system in real time and space

Ultrafast electron microscopy (UEM) has found widespread applications in physics, chemistry, and materials science, enabling real-space imaging of dynamics on ultrafast timescales. Recent advances have pushed the temporal resolution of UEM into the attosecond regime, enabling the attomicroscopy technique to directly visualize electron motion. In this work, we extend the capabilities of this powerful imaging tool to investigate ultrafast electron dynamics in a biological system by imaging and controlling light induced electronic and chemical changes in the conductive network of multicellular cable bacteria. Using electron energy loss spectroscopy (EELS), we first observed a laser induced increase in {\pi}-electron density, accompanied by spectral peak broadening and a blueshift features indicative of enhanced conductivity and structural modification. We also traced the effect of ultrafast laser pumping on bulk plasmon electron oscillations by monitoring changes in the plasmon like resonance peak. Additionally, we visualized laser induced chemical structural changes in cable bacteria in real space. The imaging results revealed carbon enrichment alongside a depletion of nitrogen and oxygen, highlighting the controllability of chemical dynamics. Moreover, time resolved EELS measurements further revealed a picosecond scale decay and recovery of both {\pi}-electron and plasmonic features, attributed to electron phonon coupling. In addition to shedding light on the mechanism of electron motion in cable bacteria, these findings demonstrate ultrafast modulation and switching of conductivity, underscoring their potential as bio-optoelectronic components operating on ultrafast timescales.

  • 7 authors
·
Oct 2, 2025